COVID-19 Update: We are still busy processing online orders and dispatching as quick as possible. Whilst the majority of deliveries arrive on time and without a problem, next day delivery service is NOT guaranteed and postal deliveries may take a little longer than usual. Thank you for understanding. Click Here for more information.

Viewed products

Top sellers

Fluke Fl-7000 INTL FiberInspector Pro

FiberInspector Pro: Versiv Main Unit and Inspection Camera, 4 tips in a box (LC, FC/SC bulkhead, 1.25 and 2.5mm universal)

00A-500-000-52

More info

Eliminate the #1 cause of fiber failure
End-face contamination is a leading cause of fiber failures. Dirt and contaminant cause insertion loss and back-reflection that inhibits optical transmission and causes havoc with transceivers. Fiber loss and OTDR testing can expose this problem, but in many cases, dirty connections make fiber testing time consuming and inaccurate.

Since dirt can be an issue before, during, or after fiber optic certification testing, and migrate from one end-face to another upon mating, both sides of any connection must always be cleaned and inspected.

Further, mating contaminated connectors can cause permanent damage as microscopic debris is crushed between end-faces in physical contact. Even factory terminated patch cords or pigtails must be inspected as protective caps do not keep end-faces clean. Avoiding this common cause of failure, starts with inspecting the end-face and eliminating any contamination before insertion into a bulkhead or piece of equipment.

Overview
  • Automated Pass/Fail acceptance testing of fiber end-faces
  • Graphical indication of problem areas due to contamination, pits, chips, and scratches
  • Large touchscreen for pinch and zoom
  • Certify to industry standards – IEC 61300-3-35
  • No more confusion about whether the fiber is good or bad
  • Eliminate human subjectivity from end-face measurements
  • Save end-face views during certification process
  • Reduce fiber inspection time with 2-second grading
  • ProjX™ system manages job requirements and progress from set-up to systems acceptance, making sure all tests are completed correctly
  • Taptive™ user interface simplifies set-up, and eliminates error
  • Analyze test results and create professional test reports using LinkWare™ management software

Features

Battery lifeEleven hour with Inspection probe attached
WeightMainframe with module and battery: 3 lbs, 5 oz (1.28 kg)
DimensionsMainframe with module and battery: 2.625 in x 5.25 in x 11.0 in ( 6.67 cm x 13.33 cm x 27.94 cm)
EMCEN 61326-1
Operating Temperature-18ºC to 45ºC
BatteryLithium ion battery pack, 7.2 volts

Data Sheet