Amplifier Probe and Tone Generator

Amplifier Probe and Tone Generator

Tone Generator and Amplifier Probe Kit

00A-001-009-39

In Stock

The Amplifier Probe is designed to identify and trace wires or cables within a group without damaging the insulation. It allows for pin point identification even in the most congested cable bundles. Our unit can be used with any tone generator.

Features:

  • Works with any Tone Generator (62-160) to identify wires
  • Battery cap allows quick and easy battery replacement
  • Volume control for increased sensitivity and adjustable to suit work environment
  • Recessed ON/OFF button prevents battery drain
  • Battery low indicator
  • 9 volt battery included
  • Tip can be replaced without opening case
  • Flat tip included

 

Tone Generator

Use the IDEAL tone generator (62-160) to apply a tone signal to a wire pair or single conductor, and trace with an amplifier probe (IDEAL 62-164). The tone generator allows technicians to identify that wire within a bundle, at a cross-connect, or at a remote end. It can be used on twisted pair, coax, and de-energized AC wiring.

Features

  • Three different tones selected from front panel
  • Tone can be added in any status – allows test sets without monitor feature to pick up tone
  • Easy to change battery – no tools needed
  • Separate Talk Battery status for increased voltage and power for test sets
  • Auto-OFF of tone after three hours to conserve battery life
  • Constant tone amplitude over life of battery
  • Two tone amplitude – normal and half
  • No power draw in continuity status with leads open
  • RJ jack allows use of modular cable or alligator clips
  • Low battery LED indicates when to change battery
  • 9 volt battery included


Ideal Networks Tone & Probe Kit part number: 33-864